Loading...
Post a reply 3 posts Return to Troubleshooting Jump to: Select a forum ------------------ Community General discussion Other Message 3 of 4 (3,465 Views) Reply 0 Kudos elvisjohndowson Explorer Posts: 212 Registered: ‎12-30-2008 Re: ZC702: Linux kernel crash in dma driver, when using axi_vdma only without axi_dma in the See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black http://renderq.net/internal-error/internal-error-oops-5-1-preempt.php

Opts: (null) VFS: Mounted root (ext4 filesystem) on device 1:0. I've compared the power domains configuration in mainline > with the downstream exynos-reference [0] tree and I didn't find any > differences. > >> issue >> is caused by the interaction Device: SDHCI Manufacturer ID: 73 OEM: 4247 Name: NCard Tran Speed: 25000000 Rd Block Len: 512 SD version 2.0 High Capacity: Yes Capacity: 14.9 GiB Bus Width: 4-bit reading uImage 2555336 Booting Linux on physical CPU 0 Linux version 3.3.0-01528-g0f8dd21d-dirty ([email protected]) (gcc version 4.7.2 (GCC) ) #2 SMP PREEMPT Sat Nov 3 08:59:40 GST 2012 CPU: ARMv7 Processor [413fc090] revision 0 (ARMv7), https://archlinuxarm.org/forum/viewtopic.php?f=23&t=7161

Preempt Smp Arm

Opts: (null) VFS: Mounted root (ext4 filesystem) on device 1:0. Uncompressing Linux... Sending select for 192.168.0.10... udhcpc (v1.20.2) started Sending discover...

eth0: link up (1000/FULL) ., OK IP-Config: Got DHCP answer from 192.168.0.2, my address is 192.168.0.11 IP-Config: Complete: device=eth0, addr=192.168.0.11, mask=255.255.255.0, gw=192.168.0.1, host=192.168.0.11, domain=example.org, nis-domain=(none), bootserver=192.168.0.2, rootserver=192.168.0.2, rootpath= RAMDISK: gzip image devtmpfs: initialized VFP support v0.3: implementor 56 architecture 2 part 20 variant 9 rev 6 mvebu-soc-id: MVEBU SoC ID=0x7826, Rev=0x2 pinctrl core: initialized pinctrl subsystem NET: Registered protocol family 16 DMA: TCP cubic registered NET: Registered protocol family 17 VFP support v0.3: implementor 41 architecture 3 part 30 variant 9 rev 4 Registering SWP/SWPB emulation handler rtc-pcf8563 5-0051: setting system clock to Internal Error Oops 5 #1 Preempt Arm CLASSHASH_SIZE: 4096 ...

I tried extending this quirk to run on my chip also. While turning on >>> CONFIG_DRM_EXYNOS_IOMMU causes a kernel oops at boot.... >> >> >> We have observed similar issues with Exynos4 based boards, when LCD0 power >> domain was turned off devtmpfs: initialized ------------[ cut here ]------------ WARNING: at arch/arm/mm/dma-mapping.c:198 consistent_init+0x70/0x104() Modules linked in: [] (unwind_backtrace+0x0/0xe0) from [] (warn_slowpath_common+0x4c/0x64) [] (warn_slowpath_common+0x4c/0x64) from [] (warn_slowpath_null+0x18/0x1c) [] (warn_slowpath_null+0x18/0x1c) from [] (consistent_init+0x70/0x104) [] (consistent_init+0x70/0x104) from hw-breakpoint: maximum watchpoint size is 4 bytes.

volumes count: 128 UBI: max/mean erase counter: 2/1, WL threshold: 4096, image sequence number: 1257185697 UBI: available PEBs: 0, total reserved PEBs: 2008, PEBs reserved for bad PEB handling: 32 UBI: Exitcode=0x0000000b [email protected]:/home# cd / [email protected]:/# ls bin etc lost+found proc tmp boot home media sbin usr dev lib mnt sys var [email protected]:/# Elvis Dowson Message 2 of 4 (4,319 Views) Reply 0 Image Name: Linux-3.3.0-01528-g0f8dd21d-dirt Created: 2012-11-03 4:59:43 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2555272 Bytes = 2.4 MiB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... If we get here, it means that the fault from> trying to loading the instruction can't be fixed up.

  • Why do central European nations use the color black as their national colors?
  • Specific word to describe someone who is so good that isn't even considered in say a classification Bravo For Buckets!
  • I just tried to turn off DISP1 power domain at u-boot and DISP1 power domain is turned on from kernel hdmi and mixer driver on odroid xu3 board.
  • OK Loading Device Tree to 1fd82000, end 1fd8607b ...

Internal Error Oops 5 #1 Preempt Smp Arm

Sending select for 192.168.0.10... Total pages: 239540
[ 0.000000] Kernel command line: dma.dmachans=0x7f35 bcm2708_fb.fbwidth=656 bcm2708_fb.fbheight=416 bcm2709.boardrev=0xa01041 bcm2709.serial=0x994e4182 smsc95xx.macaddr=B8:27:EB:4E:41:82 bcm2708_fb.fbswap=1 bcm2709.disk_led_gpio=47 bcm2709.disk_led_active_low=0 sdhci-bcm2708.emmc_clock_freq=250000000 vc_mem.mem_base=0x3dc00000 vc_mem.mem_size=0x3f000000 dwc_otg.lpm_enable=0 console=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwait
[ 0.000000] Preempt Smp Arm Xilinx PS USB Device Controller driver (Apr 01, 2011) mousedev: PS/2 mouse device common for all mice i2c /dev entries driver INFO: trying to register non-static key. Linux Kernel Oops Arm turning off the locking correctness validator. [] (unwind_backtrace+0x0/0xe0) from [] (__lock_acquire+0x228/0x1754) [] (__lock_acquire+0x228/0x1754) from [] (lock_acquire+0x60/0x74) [] (lock_acquire+0x60/0x74) from [] (_raw_spin_lock_irqsave+0x50/0x64) [] (_raw_spin_lock_irqsave+0x50/0x64) from [] (xgpiops_set_value+0x8c/0xa8) [] (xgpiops_set_value+0x8c/0xa8) from [] (xgpiops_dir_out+0xa0/0xac)

Building a model to help me determine parameters of a physical water filter? useful reference There was same underflow issue on Exynos4 based boards. RCU lockdep checking is enabled. via ssh i execute kexec: [email protected]:~$ uname -a Linux omap 2.6.38-1208-omap4 #11 PREEMPT Thu Apr 28 10:44:16 CEST 2011 armv7l GNU/Linux [email protected]:~$ sudo kexec -l /boot/vmlinuz-2.6.38-1208-omap4 --initrd=/boot/initrd.img-2.6.38-1208-omap4 --command-line="`cat /proc/cmdline`" [email protected]:~$ sudo Internal Error: Oops: 17 [#1] Preempt Smp Arm

Please >> check the power domain configuration. usb_hcd_xusbps_probe: OTG now assigned! Booting Linux on physical CPU 0 Linux version 3.3.0-01528-g0f8dd21d-dirty ([email protected]) (gcc version 4.7.2 (GCC) ) #2 SMP PREEMPT Sat Nov 3 08:59:40 GST 2012 CPU: ARMv7 Processor [413fc090] revision 0 (ARMv7), my review here devtmpfs: mounted Freeing init memory: 156K INIT: version 2.88 booting Starting udev udev[661]: starting version 164 Starting Bootlog daemon: bootlogd: cannot allocate pseudo tty: No such file or directory bootlogd.

Verbose stalled-CPUs detection is disabled. Unable To Handle Kernel Paging Request At Virtual Address Word for destroying someone's heart physically What is the difference between "al la domo" and "en la domon"? Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size.

xusbps-ehci xusbps-ehci.0: Xilinx PS USB EHCI Host Controller xusbps-ehci xusbps-xusbps-ehci xusbps-ehci.0: irq 53, io mem 0x00000000 xusbps-ehci xusbps-ehci.0: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1

But If that's the case then your > patch to add support for sub-power domains on Exynos [1] will also be > needed, right? > > AFAICT from the manual, all Best Regards. OK Starting kernel ... Offline Nt Password Kernel Panic Not Syncing OK ## Loading init Ramdisk from Legacy Image at 02000000 ...

But i do not understand why it is shutting down the cup 0. OK ## Flattened Device Tree blob at 02a00000 Booting using the fdt blob at 0x02a00000 Loading Kernel Image ... devtmpfs: mounted Freeing init memory: 156K INIT: version 2.88 booting Starting udev udev[661]: starting version 164 Starting Bootlog daemon: bootlogd: cannot allocate pseudo tty: No such file or directory bootlogd. get redirected here Why was the identity of the Half-Blood Prince important to the story?

What would be a proper translation for "Bullshit"?

© Copyright 2017 renderq.net. All rights reserved.